Add Accounts in Ledger Wallet: App Install, Account View, and Checkpoint should be handled as a account addition task with one clear order: read the device-side signal, compare the Ledger Wallet page, and write a short result before changing another condition.
Start with the required device app
The required device app is the first checkpoint because it is closest to the device state. Confirm what is visible, note the exact wording or condition, and avoid treating the whole setup as failed before this checkpoint is clear.
Compare the account view with Ledger Wallet
The account view should be compared with the current Ledger Wallet page, not with a memory of a previous session. For a related baseline, see How to Add an Account in Ledger Wallet｜App, Network, and Device-Check Order and keep only the part that matches this situation.
Use a focused checklist for completion checkpoint
The completion checkpoint is easier to read when the checklist is short and repeatable. The goal is not to change every setting, but to isolate the next useful observation.
- Confirm the device is awake and showing the expected screen.
- Check the Ledger Wallet page that belongs to this exact task.
- Change only one condition before reviewing the next result.
- Record the account record in plain notes for later comparison.
Close with the account record
The account record should name the device model, the connection or app page that was checked, and the single result that matters next. If the reader needs a narrower follow-up, continue with Steps to Create Your First Account in Ledger Wallet or review Installing the First App and Syncing with the Device.
Add Accounts in Ledger Wallet works best when the final note is practical: one device-side checkpoint, one Ledger Wallet page state, and one next comparison point. That keeps the article aligned with the setup task instead of turning it into a generic troubleshooting page.
